Distribuitor

This unit is made of Polyurethane that resist up to 260 F degrees; it is sealed and cannot be take it apart.

The Distributor accept water from the water tank through a water valve that connected through a fitting to the Electrolytic Filler. The minimum and maximum levels of  water and electrolytic volume is controlled by the Master Control through sensors installed in this unit. 

It have two fittings mounted in the bottom, one to receive the flow of water from the pump and the other to receive and filter the Hydrogen Gases generated by the Cells.

At the top it has a fitting which is connected to a water valve and to the Fuel Injector.
Hydrogennie Systems Inc. Florida USA
Technical Support Monday-Friday 9:00 AM to 5:00 PM
Phone Number 1-305-879-0679
sanabriaguido9@gmail.com
[Copyright 2002] Hydrogennie] All rights reserved