The Hydrogen Generators available in the market use Electrolysis process to generate Hydrogen. In this process when DC current passes through the
water between the electrodes disintegrates the molecular structure of the water to liberate hydrogen and oxygen gases however at the same time also
produce heat; if this current exceeds certain limits the temperature will be enough for the water to boil, producing steam, instead of gases which would
defeat the purpose.

The Hydrogennie Generators use a cooling system (thermostat, water pump, and radiator) that keep the maximum temperature under 160 degrees
Fahrenheit.  In this way we obtain an optimum production without the side effects. Water boils at 212 degrees F.

The Hydrogen Generators in the market use electrodes made out of stainless steel, the chemical composition of the electrolyte (mixtures of water
baking soda or sodium hydroxide). The electrochemical reaction in the electrolysis generates rust and others residuals on the electrodes surfaces; these
substances also change the color of the water and reduce the production of gases; as a consequence, there is need of constant maintenance which
involves changing the water and with time to change the electrodes.

The Hydrogennie Generators use electrodes made of a special alloy, a special electrolyte formula and a high frequency generator to avoid the
accumulation of oxides or rust caused by the electrochemical process maintaining the water as clear as when you filled the tank for the first time and
the electrodes free of contaminants. Eliminating the maintenance used in other products.

The Hydrogen Generators in the market Use transparent water tanks or clear tubes outside of the tanks to show the water level. In order to verify
the water level you have open the hood of your vehicle to check it.

The Hydrogennie Generators HG-1200 use a water tank that works just like your car radiator. You fill it until it overflow; there is no possibility that
you can pour more water than necessary. The water tank has a minimum water level sensor that notify the driver by a Monitor in the cabin in order to
refill the water tank when need it.

The Hydrogennie Generators HG-XXI, Use a Water Tank that contain Distilled Water, a Distributor where the water is mixed with the Electrolyte.
This Distributor has a minimum and maximum water level sensors that supply the Hydrogen Cells and notify the Driver when to refill the water tank..

The Hydrogennie Generators use the numbers displayed on the Monitor to inform you when to add electrolytic. The correct reading will show 12.75V
with the engine running, if it is greater than this number you will need to add electrolytic, follow your manual instructions. If the reading is less than
12.5 volts your battery needs charging or you used excess electrolytic when you filled the tank for the first time.

The Hydrogen Generators in the market use a manual switch to turn on the equipment, this is good; however if you forget to turn it off, very
dangerous!

The Hydrogennie Generators automatically turn the system on when you start your engine through a vacuum switch activated by the motor vacuum
when is running, as soon you turn your engine off the equipment is instantly goes off.

We are now introducing  the Master Control

This electronic device does not exist in any other hydrogen generator, and will not work in combination with any other system because in order to work
you need electronic sensors that do not exist in any other equipment on the market.

It is a logical circuit that works in conjunction with the thermostat, the minimum and maximum water level sensors,  a voltage sensor, thermostat,
vacuum switch. If all the parameters are correct your equipment, will work; if one of them is out of phase, the equipment is automatically disconnected
and your vehicle will continue working as well as before the installation of the equipment.

Also is an electronic generator of high frequency which dissolves substances generated by the process maintaining the electrodes free of impurities and
water as clear as the first day and a regulated voltage to activate the water pump.

If you have other questions feel free to contact us for an answer.
Hydrogennie Systems Inc. Florida USA
Technical Support Monday-Friday 9:00 AM to 5:00 PM
Phone Number 1-305-879-0679
sanabriaguido9@gmail.com
[Copyright 2002] Hydrogennie] All rights reserved